Spraying robots have begun to replace traditional spraying work and perform better, more valuable, and more efficient work. But in actual work, the spraying robot has to do strict work. Songle Robotics will share the work control process of the spraying robot.

Spraying robot workflow

1. The spraying robot must be controlled strictly in accordance with the relevant procedures

The spraying robot will accurately explain the relevant construction process, and there will be a dedicated person to explain it during the initial cooperation. However, in order to more accurately play the work effect of the spraying robot, relying on an accurate working process can obviously provide a better backing for the accurate realization of the work.

2. Prepare the spraying robot carefully and accurately before spraying

In fact, the preparatory work of the robot spraying work is directly related to the realization of the spraying effect. Similarly, in the process of construction and application of spray robots, related preparations need to be completed in advance. Only through the improvement of preparation work can we provide a more valuable defense for the work of the spraying robot, especially the treatment of the sprayed surface.

Third, the maintenance after the follow-up work of the spraying robot

The maintenance of the spraying robot after construction can also seriously affect the comprehensive service life of the promising spraying robot to a certain extent. Therefore, in the process of using cost-effective spray robots, maintenance work should be carried out in an orderly manner according to the content standards and requirements of the actual work. Regular maintenance can bring positive value and far-reaching significance to the improvement of the life of the spraying robot.

Relying on automatic spraying robots for spraying is no longer difficult. However, in the specific implementation process, it is necessary to do a good job of precise process control, especially the optimization of related preliminary preparations, and implement maintenance in the near future, in order to fundamentally provide more comprehensive maintenance for the work efficiency of the spray robot.

Fourth, the control of the spraying robot operation process

1. The maintenance personnel must keep the keys of the robot. It is strictly forbidden for unauthorized persons to manually enter the robot software system to read or modify programs and parameters at will.

2. In the programming, testing and maintenance of the spraying robot, we must note that even at low speed, the robot is still very powerful and has a lot of momentum, so we must put the robot in manual mode.

3. When the spraying robot is in automatic mode, it is not allowed to enter the moving area.

4. When the mobile spraying robot is not used and the program is running, the activation equipment must be released in time.

5. When an accident or abnormal situation occurs, the emergency stop button can be used to stop the operation.

6. In any case, do not use the original disk, but use the duplicate disk.

7. When the debugger enters the working area of the robot, he must carry the emergency stop device with him to prevent others from accidentally operating it by mistake.